Published

Indoor Air Quality Walkthrough: Find Sources Before You Ventilate

A practical first step for a healthier indoor environment is not shopping for a gadget; it is a room-by-room walkthrough. The EPA's introduction to indoor air quality frames the problem around pollutant sources, ventilation pathways, and the rate at which outdoor air replaces indoor air, so use those three categories as your checklist rather than guessing at a single fix [1].

Start by listing sources in each room and dividing them into continuous and intermittent. EPA notes that building materials, furnishings, and products such as air fresheners can release pollutants more or less continuously, while smoking, cleaning, redecorating, and hobbies release pollutants intermittently. Mark the continuous items on a floor plan and note the intermittent activities in a weekly calendar; that tells you where baseline attention is needed and when extra ventilation is most useful [1].

Give combustion and unvented products their own line in the inventory. EPA reports that an improperly adjusted gas stove can emit significantly more carbon monoxide than a properly adjusted one, and that unvented or malfunctioning appliances or improperly used products can release higher and sometimes dangerous levels of pollutants indoors. Record gas stoves, heaters, fireplaces, and similar equipment, and treat an unvented or malfunctioning unit as a source to correct before relying on dilution [1].

Next, trace how outdoor air can actually enter each room. EPA describes three routes: infiltration through openings, joints, cracks in walls, floors, ceilings, and around windows and doors; natural ventilation through opened windows and doors; and mechanical ventilation ranging from outdoor-vented bathroom or kitchen fans to ducted air-handling systems. For every room, note which route exists and whether it is usable; a room with no obvious infiltration, natural ventilation, or mechanical exhaust has little to drive air exchange [1].

Use the air exchange rate as a simple diagnostic idea, not a number to invent. EPA defines it as the rate at which outdoor air replaces indoor air, and notes that when infiltration, natural ventilation, and mechanical ventilation are all low, pollutant levels can increase. That is why a closed-up room can feel stale even if it looks clean, and why ventilation should be planned around the activities that generate pollutants rather than turned on only after odors become obvious [1].

Track timing and location as part of the walkthrough. EPA notes that immediate effects from indoor air pollutants can include irritation of the eyes, nose, and throat, headaches, dizziness, and fatigue, and that these can resemble colds or other viral illnesses. The useful practical step is to log when and where observations occur and whether they ease when a person leaves the area; use that log to locate possible sources, not as a medical diagnosis [1].

End with a source-control plan, not a fragrance plan. EPA points out that air fresheners are among the products that can release pollutants, so they are not a substitute for removing or isolating a source. For each room, rank actions in this order: remove or reduce the source, restore a ventilation route, then allow enough air exchange for the activity. If you are briefing a designer or builder, hand over the room-by-room inventory of continuous sources, intermittent activities, and ventilation routes; it is a concrete basis for layout and ventilation decisions without pretending to be a code review [1].

Sources and dates checked

  1. Introduction to Indoor Air Quality | US EPA (2026-11-19)

This article was created with AI assistance and checked by our automated editorial process.

General information; not a binding quote or individual investment, legal, engineering or medical advice.